liu.seSök publikationer i DiVA
Ändra sökning
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • oxford
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
Experimental Study of The Micromechanical Behaviour of Duplex Stainless Steel SAF 2507 and the Influence of Nitrogen Content
Linköpings universitet, Institutionen för ekonomisk och industriell utveckling, Konstruktionsmaterial. Linköpings universitet, Tekniska högskolan.
Sandvik Materials Technology, Sandviken.
Institute of Materials Engineering, University of Kassel, Germany.
Institute of Materials Engineering, University of Kassel, Germany.
Visa övriga samt affilieringar
2011 (Engelska)Ingår i: Materials Science Forum, ISSN 0255-5476, E-ISSN 1662-9752, Vol. 681, s. 516-521Artikel i tidskrift (Refereegranskat) Published
Abstract [en]

The deformation behaviour of four super duplex stainless steels of the grade SAF 2507 (UNS S32750) were studied by X-ray diffraction experiment with in-situ uniaxial tensile load. The steels had different nitrogen contents, between 0.2 and 0.33%, and/or different volume fractions of the ferrite, between 37% and 49%, in balance with austenite. The development of phase-specific stresses under external loading up to over 10% tensile strain was followed. The X-ray diffraction measurements revealed that load partitioning between the phases changed with increasing applied load, as the ferrite and austenite exhibited different deformation hardening behaviours. At the onset of macroscopic yielding and low plastic strains, a load transfer from γ to α occurred due to higher yield strength and strain hardening rate of the ferrite but vice versa at larger plastic strains when the austenite hardened more rapidly than the ferrite. It was also concluded that both the yield and tensile strengthen of the steels increased with increasing nitrogen content due to increased strengthen of the austenite by additional solid solution hardening, whereas a higher volume fraction of austenite contributed to higher tensile strength.

Ort, förlag, år, upplaga, sidor
Switzerland: Trans Tech Publications , 2011. Vol. 681, s. 516-521
Nyckelord [en]
Duplex stainless steels, In-situ X-ray diffraction, Micromechanical behaviour, Nitrogen content
Nationell ämneskategori
Teknik och teknologier Annan materialteknik
Identifikatorer
URN: urn:nbn:se:liu:diva-66472DOI: 10.4028/www.scientific.net/MSF.681.516OAI: oai:DiVA.org:liu-66472DiVA, id: diva2:404272
Tillgänglig från: 2011-03-16 Skapad: 2011-03-16 Senast uppdaterad: 2017-12-11Bibliografiskt granskad

Open Access i DiVA

Fulltext saknas i DiVA

Övriga länkar

Förlagets fulltext

Personposter BETA

Peng, RuJohansson, Sten

Sök vidare i DiVA

Av författaren/redaktören
Peng, RuJohansson, Sten
Av organisationen
KonstruktionsmaterialTekniska högskolan
I samma tidskrift
Materials Science Forum
Teknik och teknologierAnnan materialteknik

Sök vidare utanför DiVA

GoogleGoogle Scholar

doi
urn-nbn

Altmetricpoäng

doi
urn-nbn
Totalt: 151 träffar
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • oxford
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf