liu.seSök publikationer i DiVA
Ändra sökning
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • oxford
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
Role of Tin+ and Aln+ ion irradiation (n=1, 2) during Ti1-xAlxN alloy film growth in a hybrid HIPIMS/magnetron mode
Linköpings universitet, Institutionen för fysik, kemi och biologi, Tunnfilmsfysik. Linköpings universitet, Tekniska högskolan.ORCID-id: 0000-0002-4898-5115
Linköpings universitet, Institutionen för fysik, kemi och biologi, Tunnfilmsfysik. Linköpings universitet, Tekniska högskolan.
Sweden Seco Tools AB, Sweden .
Linköpings universitet, Institutionen för fysik, kemi och biologi, Tunnfilmsfysik. Linköpings universitet, Tekniska högskolan.
Visa övriga samt affilieringar
2012 (Engelska)Ingår i: Surface & Coatings Technology, ISSN 0257-8972, E-ISSN 1879-3347, Vol. 206, nr 19-20, s. 4202-4211Artikel i tidskrift (Refereegranskat) Published
Abstract [en]

Metastable Ti1-xAlxN (0.4 less than= x less than= 0.76) films are grown using a hybrid approach in which high-power pulsed magnetron sputtering (HIPIMS) is combined with dc magnetron sputtering (DCMS). Elemental Al and Ti metal targets are co-sputtered with one operated in HIPIMS mode and the other target in DCMS; the positions of the targets are then switched for the next set of experiments. In both cases, the AlN concentration in the co-sputtered films, deposited at T-s = 500 degrees C with R = 1.5-5.3 angstrom/s, is controlled by adjusting the average DCMS target power. Resulting films are analyzed by X-ray diffraction, scanning electron microscopy, transmission electron microscopy, atomic force microscopy, elastic recoil detection analysis, and nanoindentation. Mass spectroscopy is used to determine ion energy distribution functions at the substrate. The distinctly different flux distributions obtained from targets driven in HIPIMS vs. DCMS modes allow the effects of Aln+ and Tin+ (n = 1, 2) ion irradiation on film growth kinetics, and resulting properties, to be investigated separately. Bombardment with Aln+ ions (primarily Al+ in the Al-HIPIMS/Ti-DCMS configuration) during film growth leads to NaCl-structure Ti1-xAlxN (0.53 less than= x less than= 0.60) films which exhibit high hardness (greater than30 GPa) with low stress (0.2-0.7 GPa tensile). In contrast, films with corresponding AlN concentrations grown under Tin+ metal ion irradiation (with a significant Ti2+ component) in the Ti-HIPIMS/Al-DCMS mode have much lower hardness, 18-19 GPa, and high compressive stress ranging up to 2.7 GPa. The surprisingly large variation in mechanical properties results from the fact that the kinetic AlN solubility limit x(max) in Ti1-xAlxN depends strongly on, in addition to T-s and R, the target power configuration during growth and hence the composition of the ion flux. AlN with x(max)similar to 64 mol% can be accommodated in the NaCl structure under Aln+ ion flux, compared with similar to 40 mol% for growth with Tin+ flux. The strong asymmetry in film growth reaction paths is due primarily to the fact that the doubly-ionized metal ion flux is approximately two orders of magnitude higher from the Ti target, than from Al, powered with HIPIMS. This asymmetry becomes decisive upon application of a moderate substrate bias voltage, -60 V, applied synchronously with HIPIMS pulses, during growth.

Ort, förlag, år, upplaga, sidor
Elsevier , 2012. Vol. 206, nr 19-20, s. 4202-4211
Nyckelord [en]
HIPIMS; TiAlN; Ionized PVD; Sputtering; HPPMS
Nationell ämneskategori
Teknik och teknologier
Identifikatorer
URN: urn:nbn:se:liu:diva-79709DOI: 10.1016/j.surfcoat.2012.04.024ISI: 000305662400053OAI: oai:DiVA.org:liu-79709DiVA, id: diva2:544086
Tillgänglig från: 2012-08-13 Skapad: 2012-08-13 Senast uppdaterad: 2017-12-07

Open Access i DiVA

fulltext(791 kB)669 nedladdningar
Filinformation
Filnamn FULLTEXT01.pdfFilstorlek 791 kBChecksumma SHA-512
7a111896ca83bc16266b57b4fec64870b0b0c575ff5176a9b56049272342f7cdfcf8b95e82dfc7e720725b5e069e8b07441a73725abc1a2d2ac1ad8cc1a61ae4
Typ fulltextMimetyp application/pdf

Övriga länkar

Förlagets fulltext

Personposter BETA

Greczynski, GrzegorzLu, JunJensen, JensPetrov, IvanGreene, Joseph EHultman, Lars

Sök vidare i DiVA

Av författaren/redaktören
Greczynski, GrzegorzLu, JunJensen, JensPetrov, IvanGreene, Joseph EHultman, Lars
Av organisationen
TunnfilmsfysikTekniska högskolan
I samma tidskrift
Surface & Coatings Technology
Teknik och teknologier

Sök vidare utanför DiVA

GoogleGoogle Scholar
Totalt: 669 nedladdningar
Antalet nedladdningar är summan av nedladdningar för alla fulltexter. Det kan inkludera t.ex tidigare versioner som nu inte längre är tillgängliga.

doi
urn-nbn

Altmetricpoäng

doi
urn-nbn
Totalt: 534 träffar
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • oxford
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf