liu.seSök publikationer i DiVA
Ändra sökning
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • harvard1
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • oxford
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
Design and Performance Analysis of Low-Noise Amplifier with Band-Pass Filter for 2.4-2.5 GHz
Linköpings universitet, Institutionen för teknik och naturvetenskap, Fysik och elektroteknik. Linköpings universitet, Tekniska högskolan.
Linköpings universitet, Institutionen för teknik och naturvetenskap, Fysik och elektroteknik. Linköpings universitet, Tekniska högskolan.
2012 (Engelska)Självständigt arbete på avancerad nivå (masterexamen), 20 poäng / 30 hpStudentuppsats (Examensarbete)
Abstract [en]

Low power wireless electronics is becoming more popular due to durability, portability and small dimension. Especially, electronic devices in instruments, scientific and medical (ISM) band is convenient from the spectrum regulations and technology availability point of view. In the communication engineering society, to make a robust transceiver is always a matter of challenges for the better performance.

However, in this thesis work, a new approach of design and performance analysis of Low-Noise Amplifier with Band-Pass filter is performed at 2.45 GHz under the communication electronics research group of Institute of Science and Technology (ITN). Band-Pass Filtered Low-Noise Amplifier is designed with lumped components and transmission lines. Performances of different designs are compared with respect to noise figure, gain, input and output reflection coefficient. In the design process, a single stage LNA is designed with amplifier, ATF-58143. Maximally flat band-pass (BPF) filters were designed with lumped components and distributed elements. Afterwards, BPF is integrated with the LNA at the front side of LNA to get a compact Band-Pass Filtered Low-Noise Amplifier with good performance.

Advanced Design System (ADS) tool was used for design and simulation, and each design was tuned to get the optimum value for noise figure, gain and input reflection coefficient. LNA stand-alone gives acceptable value of noise figure and gain but the bandwidth was too wide compared to specification. Band-Pass Filtered Low-Noise Amplifier with lumped components gives also considerable values of noise and gain. But the gain was not so flat and the bandwidth was also wide. Then, Band-Pass Filtered Low-Noise Amplifier was designed with transmission lines where the optimum value of noise figure and gain was found. The gain was almost flat over the whole band, i.e., 2.4-2.5 GHz compared to LNA stand-alone and Band-Pass Filtered Low-Noise Amplifier designed with lumped components. It is observed that deviations of results from schematic to layout level are considerable, i.e., electromagnetic simulation is needed to predict the Band-Pass Filtered Low-Noise Amplifier performance.

Prototype of LNA, Band-Pass Filtered Low-Noise Amplifier with lumped and transmission lines are made at ITN’s PCB laboratory. Due to unavailability of exact values of Murata components and for some other technical reasons, the measured values of Band-Pass Filtered Low-Noise Amplifier with lumped components and transmission lines are deviated compared to predicted values from simulation.

Ort, förlag, år, upplaga, sidor
2012. , s. 69
Nationell ämneskategori
Annan elektroteknik och elektronik
Identifikatorer
URN: urn:nbn:se:liu:diva-91326ISRN: LiU-ITN-TEK-A--12/085--SEOAI: oai:DiVA.org:liu-91326DiVA, id: diva2:617192
Ämne / kurs
Elektroteknik
Uppsök
teknik
Handledare
Examinatorer
Tillgänglig från: 2013-04-22 Skapad: 2013-04-22 Senast uppdaterad: 2013-04-22Bibliografiskt granskad

Open Access i DiVA

fulltext(1365 kB)13787 nedladdningar
Filinformation
Filnamn FULLTEXT01.pdfFilstorlek 1365 kBChecksumma SHA-512
6af19dfe4547650e19c90432c5375335fda9c6872835c21106e373aa035ecd56a86d10f3518a5512935b5cfd44fe5653a9dabc396673664959d9f39f76b65ec5
Typ fulltextMimetyp application/pdf

Sök vidare i DiVA

Av författaren/redaktören
Abbasi, Muneeb MehmoodJabbar, Mohammad Abdul
Av organisationen
Fysik och elektroteknikTekniska högskolan
Annan elektroteknik och elektronik

Sök vidare utanför DiVA

GoogleGoogle Scholar
Totalt: 13787 nedladdningar
Antalet nedladdningar är summan av nedladdningar för alla fulltexter. Det kan inkludera t.ex tidigare versioner som nu inte längre är tillgängliga.

urn-nbn

Altmetricpoäng

urn-nbn
Totalt: 3102 träffar
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • harvard1
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • oxford
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf