liu.seSök publikationer i DiVA
Ändra sökning
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • oxford
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
Growth and properties of amorphous Ti-B-Si-N thin films deposited by hybrid HIPIMS/DC-magnetron co-sputtering from TiB2 and Si targets
Linköpings universitet, Institutionen för fysik, kemi och biologi, Tunnfilmsfysik. Linköpings universitet, Tekniska högskolan.
Linköpings universitet, Institutionen för fysik, kemi och biologi, Tunnfilmsfysik. Linköpings universitet, Tekniska högskolan.ORCID-id: 0000-0002-4898-5115
Linköpings universitet, Institutionen för fysik, kemi och biologi, Tunnfilmsfysik. Linköpings universitet, Tekniska högskolan.
Linköpings universitet, Institutionen för fysik, kemi och biologi, Tunnfilmsfysik. Linköpings universitet, Tekniska högskolan.
Visa övriga samt affilieringar
2014 (Engelska)Ingår i: Surface & Coatings Technology, ISSN 0257-8972, E-ISSN 1879-3347, Vol. 259, s. 442-447Artikel i tidskrift (Refereegranskat) Published
Abstract [en]

Amorphous nitrides are explored for their homogenous structure and potential use as wear-resistant coatings, beyond their much studied nano-and microcrystalline counterparts. (TiB2)1−xSixNy thin films were deposited on Si(001) substrates by a hybrid technique of high power impulse magnetron sputtering (HIPIMS) combined with dc magnetron sputtering (DCMS) using TiB2 and Si targets in a N2/Ar atmosphere. By varying the sputtering dc power to the Si target from 200 to 2000 W while keeping the average power to the TiB2-target, operated in HIPIMS mode, constant at 4000 W, the Si content in the films increased gradually from x=0.01 to x=0.43. The influence of the Si content on the microstructure, phase constituents, and mechanical properties were systematically investigated. The results show that the microstructure of as-deposited (TiB2)1−xSixNy films changes from nanocrystalline with 2-4 nm TiN grains for x=0.01 to fully electron diffraction amorphous for x=0.22. With increasing Si content, the hardness of the films increases from 8.5 GPa with x=0.01 to 17.2 GPa with x=0.43.

Ort, förlag, år, upplaga, sidor
Elsevier, 2014. Vol. 259, s. 442-447
Nationell ämneskategori
Fysik
Identifikatorer
URN: urn:nbn:se:liu:diva-106574DOI: 10.1016/j.surfcoat.2014.10.053ISI: 000347605200010OAI: oai:DiVA.org:liu-106574DiVA, id: diva2:716728
Tillgänglig från: 2014-05-12 Skapad: 2014-05-12 Senast uppdaterad: 2017-12-05Bibliografiskt granskad
Ingår i avhandling
1. Growth and Characterization of Amorphous Multicomponent Nitride Thin Films
Öppna denna publikation i ny flik eller fönster >>Growth and Characterization of Amorphous Multicomponent Nitride Thin Films
2014 (Engelska)Doktorsavhandling, sammanläggning (Övrigt vetenskapligt)
Abstract [en]

This thesis explores deposition of amorphous thin films based on the two transition metal nitride systems, TiN and HfN. Additions of Si, Al and B have been investigated using three different deposition techniques: dc magnetron sputtering, cathodic arc evaporation, and high power impulse magnetron sputtering (HIPIMS). The effect of elemental composition, bonding structure, growth temperature, and low-energy ion bombardment during growth has been investigated and correlated to the resulting microstructure and mechanical properties of the films. The thermal stability has been investigated by annealing experiments.

Deposition by cathodic arc evaporation yields dense and homogeneous coatings with essentially fully electron-diffraction amorphous structures with additions of either Al+Si, B+Si or B+Al+Si to TiN. The B-containing coatings have unusually few macroparticles. Annealing experiments show that Ti-Al-Si-N coatings have an age hardening behavior, which is not as clear for B-containing coatings. Compositional layering, due to rotation of the sample fixture during deposition, is present but not always visible in the as-deposited state. The layering acts as a template for renucleation during annealing. The coatings recrystallize by growth of TiN-rich  domains.

Amorphous growth by conventional dc magnetron sputtering is possible over a wide range of compositions for Ti-B-Si-N thin films. The Ti content in the films is reduced compared to the content in the sputtering target. Without Si, the films consist of a BN onion-like structure surrounding TiN nanograins. With additions of Si the films eventually grows fully amorphous. The growth temperature has only minor effect on the microstructure, due to the limited surface diffusion at the investigated temperature range (100-600 °C). Ion assisted growth leads to nanoscale densification of the films and improved mechanical properties.

Ti-B-Si-N thin films are also deposited by a hybrid technique where dc magnetron sputtering is combined with HIPIMS. Here, the Ti:B ratio remains equal to the target composition. Films with low Si content are porous with TiN nanograins separated by BN-rich amorphous channels and have low hardness. Increasing Si contents yield fully electron-amorphous films with higher hardness.

Finally, Hf-Al-Si-N single-layer and multilayer films are grown by dc magnetron sputtering from a single Hf-Al-Si target. Amorphous growth is achieved when the growth temperature was kept at its minimum. Low-energy substrate bias modulation is used to grow nanocomposite/nanocolumnar multilayers from the single Hf-Al-Si target, where the layers has essentially the same composition but different Si bonding structure, and different degree of crystallinity.

Ort, förlag, år, upplaga, sidor
Linköping: Linköping University Electronic Press, 2014. s. 92
Serie
Linköping Studies in Science and Technology. Dissertations, ISSN 0345-7524 ; 1595
Nationell ämneskategori
Naturvetenskap
Identifikatorer
urn:nbn:se:liu:diva-106576 (URN)10.3384/diss.diva-106576 (DOI)978-91-7519-337-3 (ISBN)
Disputation
2014-05-28, Planck, Fysikhuset, Campus Valla, Linköping, 10:00 (Engelska)
Opponent
Handledare
Tillgänglig från: 2014-05-12 Skapad: 2014-05-12 Senast uppdaterad: 2019-11-19Bibliografiskt granskad

Open Access i DiVA

fulltext(7384 kB)378 nedladdningar
Filinformation
Filnamn FULLTEXT01.pdfFilstorlek 7384 kBChecksumma SHA-512
bfd07e5a89c66d0479e110de588d7dfd0c54d2372bccfd31f37662bd9ba5223cbee4e0716d520f1d2b9510841fca90081be22bf1458409d2d29f0e8122bb5eeb
Typ fulltextMimetyp application/pdf

Övriga länkar

Förlagets fulltext

Personposter BETA

Fager, HannaGreczynski, GrzegorzJensen, JensLu, JunHultman, Lars

Sök vidare i DiVA

Av författaren/redaktören
Fager, HannaGreczynski, GrzegorzJensen, JensLu, JunHultman, Lars
Av organisationen
TunnfilmsfysikTekniska högskolan
I samma tidskrift
Surface & Coatings Technology
Fysik

Sök vidare utanför DiVA

GoogleGoogle Scholar
Totalt: 378 nedladdningar
Antalet nedladdningar är summan av nedladdningar för alla fulltexter. Det kan inkludera t.ex tidigare versioner som nu inte längre är tillgängliga.

doi
urn-nbn

Altmetricpoäng

doi
urn-nbn
Totalt: 415 träffar
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • oxford
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf