liu.seSearch for publications in DiVA
Change search
ReferencesLink to record
Permanent link

Direct link
Development and Analysis of Synchronization Process Control Algorithms in a Dual Clutch Transmission
Linköping University, Department of Electrical Engineering.
2009 (English)Independent thesis Advanced level (professional degree), 20 credits / 30 HE creditsStudent thesis
Abstract [en]

The Dual Clutch Transmission (DCT) is a relatively new kind of transmission which shows increased efficiency and comfort compared to manual transmissions. Its construction is much like two parallell manual transmissions, where the gearshifts are controlled automatically. The gear-shift of a manual transmission involves a synchronization process, which synchronizes and locks the input shaft to the output shaft via the desired gear ratio. This process, which means transportation of a synchronizer sleeve, is performed by moving the gear shift lever which is connected to the sleeve. In a DCT, there is no mechanical connection between the gear-shift lever and the sleeve. Hence, an actuator system, controlled by a control system, must be used.

This report includes modelling, control system design and simulation results of a DCT synchronization process. The thesis work is performed at GM Powertrain (GMPT) in Trollhättan. At the time of this thesis, there is no DCT produced by GM, and therefore the results and conclusions rely on simulations. Most of the used system parameters are reasonable values collected from employees at GMPT and manual transmission literature.

The focus of the control design is to achieve a smooth, rather than fast, movement of the synchronizer sleeve. Simulations show that a synchronization process can be performed in less than 400 ms under normal conditions. The biggest problems controlling the sleeve position occur if there is a large amount of drag torque affecting the input shaft. Delay problems also worsen the performance a lot. An attempt to predict the synchronizer sleeve position is made and simulations shows advantages of that.

Some further work is needed before the developed control software can be used on a real DCT. Investigations of sensor noise robustness and the impact of dogging forces are the most important issues to be further investigated. Implementation of additional functionality for handling special conditions are also needed.

Place, publisher, year, edition, pages
2009. , 105 p.
Keyword [en]
dct, dsg, amt, synch, synchronizer, detent, dogging, gear shift, synchronization
National Category
Control Engineering
URN: urn:nbn:se:liu:diva-17179ISRN: LITH-ISY-EX--09/4191--SEOAI: diva2:202183
Glashuset, 581 83, LINKÖPING (Swedish)
Available from: 2009-03-09 Created: 2009-03-08 Last updated: 2009-03-09Bibliographically approved

Open Access in DiVA

fulltext(2946 kB)2203 downloads
File information
File name FULLTEXT01.pdfFile size 2946 kBChecksum SHA-512
Type fulltextMimetype application/pdf

Search in DiVA

By author/editor
Gustavsson, Andreas
By organisation
Department of Electrical Engineering
Control Engineering

Search outside of DiVA

GoogleGoogle Scholar
Total: 2203 downloads
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Total: 1073 hits
ReferencesLink to record
Permanent link

Direct link