Analysis of an induction regulator for power flow control in electric power transmission systems
Independent thesis Basic level (professional degree), 20 points / 30 hpStudent thesis
Controlling the power flow in transmission systems has recently gained increased interest. The difficulties of building new lines and the pressure of having a high utilization of existing assets, makes the flexibility of grid systems increasingly important.
This master thesis work investigates induction regulators as control devices for active power flow in a transmission system. A small change in angle of the rotor affects both the amplitude and the phase of the voltage. The magnetic coupling in the induction regulator can be controlled by changing the permeability of a thermo magnetic material such as gadolinium and can hence give a second independent controlling parameter. An analytical model and calculations in the
FEM software AceTripleC together with Matlab, is used to simulate the influence of the regulators connected to a simple grid in case1, a 400 kV scenario and case 2, a 45 kV scenario.
The analysis was carried out on a small transmission system consisting of two parallel transmission lines connected to source and load. The induction regulators are connected to one of the parallel transmission lines. The regulators modelled in case 1 must be able to control the active power flow in the regulated line to vary between 50 and 150 % of the original power flow through this line.
This shall be done over a range of 0 to 800 MW transmitted power. The regulators modelled in case 2 must be able to control the active power flow in
the regulated line to vary between 0 and 30 MW, if this does not cause the power flow in the parallel line to exceed 30 MW. This shall be done over a range of 0 to
50 MW transmitted power.
The regulators are designed as small and inexpensive as possible while still fulfilling requirements regarding the active power flow controllability in the grid, current density in windings and maximum flux density in core and gap.
The results indicate that the size of the 400 kV solution has to be reduced to become competitive whereas for the 45 kV solution the relative difference to existing solution is smaller. Advantages with the proposed design over a phase shifting transformer are mainly a simpler winding scheme and the absence of a tap changer.
Place, publisher, year, edition, pages
Institutionen för fysik, kemi och biologi , 2005. , 90 p.
Power flow control, Phase shifting, Induction regulator, Gadolinium
IdentifiersURN: urn:nbn:se:liu:diva-5329ISRN: LITH-IFM-EX—05/1543--SEOAI: oai:DiVA.org:liu-5329DiVA: diva2:21264