Modellering av manövercylindern för Nosstället på JAS39 Gripen
Independent thesis Advanced level (degree of Magister), 20 points / 30 hpStudent thesis
When models are used to describe physical phenomenon during development or modification of a technical system, it is often possible to reduce both the time needed and the overall development cost. With the use of models it is also possible to investigate the potential of the selected solution, without the need for any expensive details and testrigs. In many cases it is also not possible to test all the aspects regarding the functionality that are desired from the system, without using the complete and final product.
In this case a model based approach has been used to optimize the different parameters in the new snubbing mechanism for the Nose Landing Gear Retract Actuator on the JAS39 Gripen.
During the simulations, upper and lower boundaries were calculated for the length of the spring and the diameter for the restrictor. The governing constraints were given by the requirements for the retraction time during cold conditions and that the amplitude of the alternating loads in the uplock mechanism were brought to an acceptable level.
The most promising results from the simulations were then used in a limited number of trials in the hydraulic rig to verify that the configurations comply with the requirements.
The final parameters for the snubbing mechanism were chosen to 35±1mm for the spring and 0.4-0.5 mm diameter for the restrictor.
Place, publisher, year, edition, pages
Institutionen för systemteknik , 2005. , 104 p.
modellering ändlägesdämpning hydraulik nosställ frekvensanalys
IdentifiersURN: urn:nbn:se:liu:diva-6074ISRN: LiTH-ISY-EX--05/3575--SEOAI: oai:DiVA.org:liu-6074DiVA: diva2:21627