liu.seSearch for publications in DiVA
Change search
ReferencesLink to record
Permanent link

Direct link
Simulation and Evaluation of Two Different Skin Thermocouples: A Comparison made with Respect to Measured Temperature
Linköping University, Department of Management and Engineering.
2007 (English)Independent thesis Advanced level (degree of Magister), 20 points / 30 hpStudent thesis
Abstract [en]

The demand for more accurate measurements is increasing in today’s industry. One reason for this is to optimize production and thus maximize profits. Another reason is that in some cases government regulations dictate that supervision of certain parameters must be followed. At Preemraff Lysekil there are basically four reasons for measuring skin temperatures inside fired process heaters, namely; because of government regulations, in order to estimate the load of the fired process heater, to estimate the lifetime of the tubes inside the fired process heater and finally, to determine the need of decoking. However, only the first three of these reasons are applied to H2301/2/3. The current skin thermocouple design has been in use for many years and now the question of how well it measures surface temperature has risen. Furthermore a new weld-free design is under consideration to replace the old skin thermocouple design. Another question is therefore how well the new design can measure the surface temperature under the same operating conditions as the old one. In order to evaluate this, three–dimensional computer simulations were made of the different designs. As this thesis will show, the differences in calculated skin thermocouple temperature and calculated surface temperature is about the same for the two designs. However, the current design will show a lower temperature than the surface temperature, while the new design will show a higher temperature. Regarding the core of the skin thermocouple designs, namely the thermocouple, no hard conclusions can be drawn, although the industry appears to favor type ’N’ over type ’K’.

Place, publisher, year, edition, pages
Institutionen för ekonomisk och industriell utveckling , 2007. , 52 p.
Keyword [en]
Skin thermocouple, Heat Transfer, Type K, Type N, Seebeck coefficient
National Category
Energy Engineering
URN: urn:nbn:se:liu:diva-8519ISRN: LIU-IEI-TEK-A--07/0076--SEOAI: diva2:23296
Available from: 2007-03-23 Created: 2007-03-23

Open Access in DiVA

fulltext(1911 kB)2510 downloads
File information
File name FULLTEXT01.pdfFile size 1911 kBChecksum MD5
Type fulltextMimetype application/pdf

By organisation
Department of Management and Engineering
Energy Engineering

Search outside of DiVA

GoogleGoogle Scholar
Total: 2510 downloads
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Total: 577 hits
ReferencesLink to record
Permanent link

Direct link