liu.seSearch for publications in DiVA
Change search
ReferencesLink to record
Permanent link

Direct link
Five Geometric Principles for Injection Molding
Linköping University, Department of Mathematics, Applied Mathematics. Linköping University, The Institute of Technology.
2003 (English)In: International polymer processing, ISSN 0930-777X, Vol. 18, no 1, 91-94 p.Article in journal (Refereed) Published
Abstract [en]

A condensed presentation of some results of a geometric character, concerning the injection molding of plastics, is given here. The author has derived these results from mathematical arguments and some simplifying assumptions, besides the usual Hele-Shaw flow conditions.

The presentation here is intended for readers with an interest in polymer processing, rather than mathematics, so that the mathematical derivations are omitted in some cases, and sketchy in other cases. Instead we try to explain the results using figures, intuitive arguments and a few inevitable formulas. Since the experimental verification of the results is still very incomplete, we prefer to present them as proposed principles. Comments and suggestions for improvement are very welcome.

Place, publisher, year, edition, pages
Munich, Germany: Carl Hanser Verlag GmbH, 2003. Vol. 18, no 1, 91-94 p.
National Category
URN: urn:nbn:se:liu:diva-22986DOI: 10.3139/217.1723ISI: 000182839700013Local ID: 2360OAI: diva2:243299
Available from: 2009-10-07 Created: 2009-10-07 Last updated: 2014-08-20Bibliographically approved

Open Access in DiVA

No full text

Other links

Publisher's full text

Search in DiVA

By author/editor
Aronsson, Gunnar
By organisation
Applied MathematicsThe Institute of Technology
In the same journal
International polymer processing

Search outside of DiVA

GoogleGoogle Scholar
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Altmetric score

Total: 214 hits
ReferencesLink to record
Permanent link

Direct link