liu.seSearch for publications in DiVA
Change search
ReferencesLink to record
Permanent link

Direct link
Residual generation for fault diagnosis
Linköping University, Department of Electrical Engineering. Linköping University, The Institute of Technology.
2001 (English)Doctoral thesis, monograph (Other academic)
Abstract [en]

The objective when supervising technical processes is to alarm an operator when a fault is detected and also identify one, or possibly a set of components, that may have been the cause of the alarm. Diagnosis is an expansive subject, partly due to the fact that nowadays, more applications have more embedded computing power and more available sensors than before.

A fundamental part of many model-based diagnosis algorithms are so called residuals. A residual is a signal that reacts to a carefully chosen subset of the considered faults and by generating a suitable set of such residuals, fault detection and isolation can be achieved.

A common thread is the development of systematic design and analysis methods for residual generators based on a number of different model classes, namely deterministic and stochastic linear models on state-space, descriptor, or transfer function form, and non-linear polynomial systems. In addition, it is considered important that there exist readily available computer tools for all design algorithms.

A key result is the minimal polynomial basis algorithm that is used to parameterize all possible residual generators for linear model descriptions. It also, explicitly, finds those solutions of minimal order. The design process and its numerical properties are shown to be sound. The algorithms and its principles are extended to descriptor systems, stochastic systems, nonlinear polynomial systems, and uncertain linear systems. Kew results from these extensions include: increased robustness by introduction of a reference model, a new type of whitening filters for residual generation for stochastic systems both on state-space form and descriptor form, and means to handle algorithmic complexity for the non-linear design problem.

In conclusion, for the four classes of models studied, new methods have been developed. The methods fulfills requirements generation of all possible solutions, availability of computational tools, and numerical soundness. The methods also provide the diagnosis system designer with a set of tools with well specified and intuitive design freedom

Place, publisher, year, edition, pages
Linköping: Linköpings universitet , 2001. , 174 p.
Linköping Studies in Science and Technology. Dissertations, ISSN 0345-7524 ; 716
National Category
Engineering and Technology
URN: urn:nbn:se:liu:diva-39502Local ID: 49055ISBN: 91-7373-115-3OAI: diva2:260351
Public defence
2001-11-20, Visionen, B-huset, Linköpings Universitet, Linköping, 10:15 (Swedish)
Available from: 2009-10-10 Created: 2009-10-10 Last updated: 2016-04-18Bibliographically approved

Open Access in DiVA

Residual generation for fault diagnosis(1544 kB)300 downloads
File information
File name FULLTEXT01.pdfFile size 1544 kBChecksum SHA-512
Type fulltextMimetype application/pdf

Search in DiVA

By author/editor
Frisk, Erik
By organisation
Department of Electrical EngineeringThe Institute of Technology
Engineering and Technology

Search outside of DiVA

GoogleGoogle Scholar
Total: 300 downloads
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Total: 138 hits
ReferencesLink to record
Permanent link

Direct link