liu.seSearch for publications in DiVA
Change search
ReferencesLink to record
Permanent link

Direct link
Carbide and nanocomposite thin films in the Ti-Pt-C system
Uppsala University.
Linköping University, Department of Physics, Chemistry and Biology, Applied Physics . Linköping University, The Institute of Technology.
Linköping University, Department of Physics, Chemistry and Biology. Linköping University, The Institute of Technology.
Linköping University, Department of Physics, Chemistry and Biology, Thin Film Physics. Linköping University, The Institute of Technology.ORCID iD: 0000-0002-2837-3656
Show others and affiliations
2010 (English)In: Thin Solid Films, ISSN 0040-6090, E-ISSN 1879-2731, Vol. 518, no 18, 5104-5109 p.Article in journal (Refereed) Published
Abstract [en]

Thin films in the Ti-Pt-C system were deposited by non-reactive, DC-magnetron sputtering. Samples were characterised using X-ray photoelectron spectroscopy, X-ray diffraction, and transmission electron microscopy. A previously not reported metastable solid solution carbide, (Ti1-xPtx)C-y with a Pt/Ti ratio of up to 0.43 was observed. This solid solution phase was present both as single phase in polycrystalline samples, and together with amorphous carbon (a-C) in nanocomposite samples. Annealing of nanocomposite samples leads to the decomposition of the solid solution phase and the formation of a nc-TiCx/a-C/nc-Pt nanocomposite. Test sensors for automotive gas exhausts manufactured from such a three-phase material suffer from complete oxidation of the coating at 400 degrees C with no observed sensor activity.

Place, publisher, year, edition, pages
Elsevier Science B.V., Amsterdam. , 2010. Vol. 518, no 18, 5104-5109 p.
Keyword [en]
Solid solution carbide; Nanocomposite; Sputtering; Gas sensor; Annealing; Transmission electron microscopy; X-ray photoelectron spectroscopy; X-ray diffraction
National Category
Engineering and Technology
URN: urn:nbn:se:liu:diva-58177DOI: 10.1016/j.tsf.2010.03.017ISI: 000279659900013OAI: diva2:342901
Original Publication: Erik Lewin, Kristina Buchholt, Jun Lu, Lars Hultman, Anita Lloyd Spetz and Ulf Jansson, Carbide and nanocomposite thin films in the Ti-Pt-C system, 2010, Thin Solid Films, (518), 18, 5104-5109. Copyright: Elsevier Science B.V., Amsterdam. Available from: 2010-08-11 Created: 2010-08-09 Last updated: 2016-08-31
In thesis
1. Nanostructured materials for gas sensing applications
Open this publication in new window or tab >>Nanostructured materials for gas sensing applications
2011 (English)Doctoral thesis, comprehensive summary (Other academic)
Abstract [en]

In this Thesis I have investigated the use of nanostructured films as sensing and contact layers for field effect gas sensors in order to achieve high sensitivity, selectivity, and long term stability of the devices in corrosive environments at elevated temperatures. Electrochemically synthesized Pd and Au nanoparticles deposited as sensing layers on capacitive field effect devices were found to give a significant response to NOx with small, or no responses to H2, NH3, and C3H6. Pt nanoparticles incorporated in a TiC matrix are catalytically active, but the agglomeration and migration of the Pt particles towards the substrate surface reduces the activity of the sensing layer. Magnetron sputtered epitaxial films from the Ti-Si-C and the Ti-Ge-C systems were grown on 4H-SiC substrates in order to explore their potential as high temperature stable ohmic contact materials to SiC based field effect gas sensors. Ti3SiC2 thin films deposited on 4H-SiC substrates were found to yield ohmic contacts to n-type SiC after a high temperature rapid thermal anneal at 950 ºC. Investigations on the growth mode of Ti3SiC2 thin films with varying Si content on 4H-SiC substrates showed the growth to be lateral step-flow with the propagation of steps with a height as small as half a unit cell. The amount of Si present during deposition leads to differences in surface faceting of the films and Si-supersaturation conditions gives growth of Ti3SiC2 films with the presence of TiSi2 crystallites. Current-voltage measurements of the as-deposited Ti3GeC2 films indicate that this material is also a promising candidate for achieving long term stable contact layers to 4H-SiC for operation at elevated temperatures in corrosive environments. Further investigations into the Ti-Ge-C system showed that the previously unreported solid solutions of (Ti,V)2GeC, (Ti,V)3GeC2 and (Ti,V)4GeC3 can be synthesized, and it was found that the growth of these films is affected by the nature of the substrate.

Place, publisher, year, edition, pages
Linköping: Linköping University Electronic Press, 2011. 61 p.
Linköping Studies in Science and Technology. Dissertations, ISSN 0345-7524 ; 1377
National Category
Natural Sciences
urn:nbn:se:liu:diva-69641 (URN)978‐91‐7393‐140‐3 (ISBN)
Public defence
2011-09-09, Planck, Fysikhuset, Campus Valla, Linköpings universitet, Linköping, 10:15 (English)
Available from: 2011-07-08 Created: 2011-07-08 Last updated: 2016-08-31Bibliographically approved

Open Access in DiVA

fulltext(1121 kB)736 downloads
File information
File name FULLTEXT01.pdfFile size 1121 kBChecksum SHA-512
Type fulltextMimetype application/pdf

Other links

Publisher's full text

Search in DiVA

By author/editor
Buchholt, KristinaLu, JunHultman, LarsLloyd Spetz, Anita
By organisation
Applied Physics The Institute of TechnologyDepartment of Physics, Chemistry and BiologyThin Film Physics
In the same journal
Thin Solid Films
Engineering and Technology

Search outside of DiVA

GoogleGoogle Scholar
Total: 736 downloads
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Altmetric score

Total: 221 hits
ReferencesLink to record
Permanent link

Direct link