liu.seSearch for publications in DiVA
Change search
ReferencesLink to record
Permanent link

Direct link
Experimental Study of The Micromechanical Behaviour of Duplex Stainless Steel SAF 2507 and the Influence of Nitrogen Content
Linköping University, Department of Management and Engineering, Engineering Materials. Linköping University, The Institute of Technology.
Sandvik Materials Technology, Sandviken.
Institute of Materials Engineering, University of Kassel, Germany.
Institute of Materials Engineering, University of Kassel, Germany.
Show others and affiliations
2011 (English)In: Materials Science Forum, ISSN 0255-5476, Vol. 681, 516-521 p.Article in journal (Refereed) Published
Abstract [en]

The deformation behaviour of four super duplex stainless steels of the grade SAF 2507 (UNS S32750) were studied by X-ray diffraction experiment with in-situ uniaxial tensile load. The steels had different nitrogen contents, between 0.2 and 0.33%, and/or different volume fractions of the ferrite, between 37% and 49%, in balance with austenite. The development of phase-specific stresses under external loading up to over 10% tensile strain was followed. The X-ray diffraction measurements revealed that load partitioning between the phases changed with increasing applied load, as the ferrite and austenite exhibited different deformation hardening behaviours. At the onset of macroscopic yielding and low plastic strains, a load transfer from γ to α occurred due to higher yield strength and strain hardening rate of the ferrite but vice versa at larger plastic strains when the austenite hardened more rapidly than the ferrite. It was also concluded that both the yield and tensile strengthen of the steels increased with increasing nitrogen content due to increased strengthen of the austenite by additional solid solution hardening, whereas a higher volume fraction of austenite contributed to higher tensile strength.

Place, publisher, year, edition, pages
Switzerland: Trans Tech Publications , 2011. Vol. 681, 516-521 p.
Keyword [en]
Duplex stainless steels, In-situ X-ray diffraction, Micromechanical behaviour, Nitrogen content
National Category
Engineering and Technology Other Materials Engineering
URN: urn:nbn:se:liu:diva-66472DOI: 10.4028/ diva2:404272
Available from: 2011-03-16 Created: 2011-03-16 Last updated: 2011-04-13Bibliographically approved

Open Access in DiVA

No full text

Other links

Publisher's full text

Search in DiVA

By author/editor
Peng, RuJohansson, Sten
By organisation
Engineering MaterialsThe Institute of Technology
In the same journal
Materials Science Forum
Engineering and TechnologyOther Materials Engineering

Search outside of DiVA

GoogleGoogle Scholar
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Altmetric score

Total: 105 hits
ReferencesLink to record
Permanent link

Direct link