Schottky diodes were fabricated on the HVPE-grown, free-standing gallium nitride (GaN) layers of n- and p-types. Both contacts (ohmic and Schottky) were deposited on the top surface using Al/Ti and Pd/Ti/Au, respectively. The Schottky diode fabricated on n-GaN exhibited double barriers with values of 0.9 and 0.6 eV and better performance in the rectification factor together with reverse and forward currents with an ideality factor of 1.8. The barrier height for the p-GaN Schottky diode is 0.6 eV with an ideality factor of 4.16. From the capacitance-voltage (C-V) measurement, the net doping concentration of n-GaN is 4 x 10(17) cm(-3), resulting in a lower reverse breakdown of around -12 V. The interface state density (N-SS) as a function of E-C-E-SS is found to be in the range 4.23 x 10(12)-3.87 x 10(11) eV(-1) cm(-2) (below the conduction band) from Ec-0.90 to E-C-0.99. Possible reasons responsible for the low barrier height and high ideality factor have been addressed.

Annealing effects on optical and electrical properties of n-ZnO/p-Si heterojunction diodes are studied. ZnO nanorods are grown on p-Si substrate by aquous chemical growth technique. As grown samples were annealed at 400 and 600 ^oC in air, oxygen and nitrogen ambient. Structural, optical and electrical characteristics are studied by Scanning Electron Microscopy (SEM), Photoluminescence (PL), Current–Voltage (I-V) and Capacitance-Voltage (CV) measurements. Well aligned hexagonal–shaped vertical nanorods are revealed in SEM. PL spectra indicated higher ultraviolet to visible emission ratio with a strong peak ofnear band edge emission (NBE) and weak broad deep-level emissions (DLE). For device fabrication Al/Pt non-alloyed ohmic contacts have been evaporated. I-V characteristics indicate that annealing in air and oxygen resulted in better rectifying behavior as well as decrease in reverse leakage current. An improvement in PL intensity has been shown by the samples annealed at 400 ^oC.

Modeling of Pd/ZnO Schottky diode has been performed together with a set of simulations to investigate its behavior in current-voltage characteristics. The diode was first fabricated and then the simulations were performed to match the IV curves to investigate the possible defects and their states in the bandgap. The doping concentration measured by capacitancevoltage is 3.4 x 1017 cm-3. The Schottky diode is simulated at room temperature and the effective barrier height is determined from current voltage characteristics both by measurements and simulations and it was found to be 0.68eV. The ideality factor obtained from simulated results is 1.06-2.04 which indicates that the transport mechanism is thermionic. It was found that the recombination current in the depletion region is responsible for deviation of experimental values from the ideal thermionic model deployed by the simulator.