liu.seSearch for publications in DiVA
Change search
ReferencesLink to record
Permanent link

Direct link
Model Based Diagnosis of an Air Source Heat Pump
Linköping University, Department of Electrical Engineering, Vehicular Systems.
2011 (English)Independent thesis Advanced level (degree of Master (Two Years)), 20 credits / 30 HE creditsStudent thesisAlternative title
Modellbaserad Diagnos av en Luftvärmepump (Swedish)
Abstract [en]

The purpose of a heat pump is to control the temperature of an enclosed space. This is done by using heat exchange with a heat source, for example water, air, or ground. In the air source heat pump that has been studied during this master thesis, a refrigerant exchanges heat with the outdoor air and with a water distribution system.

The heat pump is controlled through the circuit containing the refrigerant and it is therefore crucial that this circuit is functional. To ensure this, a diagnosis system has been created, to be able to detect and isolate sensor errors. The diagnosis system is based on mathematical models of the refrigerant circuit with its main components: a compressor, an expansion valve, a plate heat exchanger, an air heat exchanger, and a four-way valve. Data has been collected from temperature- and pressure sensors on an air source heat pump. The data has then been divided into data for model estimation and data for model validation. The models are used to create test quantities, which in turn are used by a diagnosis algorithm to determine whether an error has occurred or not.

There are nine temperature sensors and two pressure sensors on the studied air source heat pump. Four fault modes have been investigated for each sensor: Stuck, Offset, Short circuit and Open circuit. The designed diagnosis system is able to detect all of the investigated error modes and isolate 40 out of 44 single errors. However, there is room for improvement by constructing more test quantities to detect errors and decouple more fault modes. To further develop the diagnosis system, the existing models can be improved and new models can be created.

Place, publisher, year, edition, pages
2011. , 40 p.
Keyword [en]
modelling, diagnosis, vapour compression system
National Category
Other Electrical Engineering, Electronic Engineering, Information Engineering
URN: urn:nbn:se:liu:diva-71423ISRN: LiTH-ISY-EX--11/4502--SEOAI: diva2:448339
Subject / course
Vehicular Systems
Physics, Chemistry, Mathematics
Available from: 2011-10-17 Created: 2011-10-16 Last updated: 2011-10-17Bibliographically approved

Open Access in DiVA

fulltext(1023 kB)8894 downloads
File information
File name FULLTEXT01.pdfFile size 1023 kBChecksum SHA-512
Type fulltextMimetype application/pdf

By organisation
Vehicular Systems
Other Electrical Engineering, Electronic Engineering, Information Engineering

Search outside of DiVA

GoogleGoogle Scholar
Total: 8894 downloads
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Total: 370 hits
ReferencesLink to record
Permanent link

Direct link