liu.seSearch for publications in DiVA
Change search
ReferencesLink to record
Permanent link

Direct link
Off-normal Film Growth by High Power Impulse Magnetron Sputtering
Linköping University, Department of Physics, Chemistry and Biology, Plasma and Coating Physics.
2011 (English)Independent thesis Advanced level (degree of Master (Two Years)), 20 credits / 30 HE creditsStudent thesis
Abstract [en]

In this study we contribute towards establishing the process-microstructure relationships in thin films grown off-normally by ionized physical vapor deposition. High power impulse magnetron sputtering (HiPIMS) is used at various peak target powers and deposition rates to grow copper (Cu) and chromium (Cr) films from a cathode placed at an angle 90 degrees with respect to the substrate normal. Films are also deposited by direct current magnetron sputtering (DCMS), for reference. Scanning electron microscopy is employed to investigate column tilting and deposition rate while X-ray diffraction techniques are utilized to study crystal structure and grain tilting.

It is demonstrated that the columnar structure of Cu tilts less with respect to the substrate normal as the peak target power increases, which has been shown to correspond to a higher ionization degree of the sputtered material [1]. One explanation for this is that the trajectories of the ions are deflected towards the substrate and therefore deposited closer to the normal, as has been suggested in the literature (see e.g. [2]). Energetic bombardment by ions might also increase surface mobility, which further raises the columns. It is also concluded that the change in tilting is not caused by a lower deposition rate obtained when employing HiPIMS. The same is not seen for Cr, where all deposited films exhibit the same tilting angle. When the column tilting of Cu and Cr is compared a large difference is observed, where the columns of Cr are closer to the substrate normal. The reasons for this difference are discussed in light of nucleation and growth characteristics in the two materials.

X-ray diffraction analysis reveals that Cu films exhibit an (111) fiber texture. Comparison of films grown by DCMS and HiPIMS shows that in the HiPIMS cases the grains are closer to the surface normal and better oriented with each other. In the case of Cr both DCMS and HiPIMS grown films are (110) biaxially aligned. 

Place, publisher, year, edition, pages
2011. , 44 p.
Keyword [en]
HiPIMS, HPPMS, glancing angle deposition
National Category
Condensed Matter Physics
URN: urn:nbn:se:liu:diva-71315ISRN: LiTH-IFM-A-EX--11/2563--SEOAI: diva2:450251
Subject / course
2011-10-13, Röntgen (P404), Fysikhuset, Linköpings universitet, Linköping, 14:00 (English)
Physics, Chemistry, Mathematics
Available from: 2011-10-24 Created: 2011-10-11 Last updated: 2012-01-05Bibliographically approved

Open Access in DiVA

Johansson - Off-normal Film Growth by High Power Impulse Magnetron Sputtering(7279 kB)269 downloads
File information
File name FULLTEXT01.pdfFile size 7279 kBChecksum SHA-512
Type fulltextMimetype application/pdf

By organisation
Plasma and Coating Physics
Condensed Matter Physics

Search outside of DiVA

GoogleGoogle Scholar
Total: 269 downloads
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Total: 144 hits
ReferencesLink to record
Permanent link

Direct link