liu.seSearch for publications in DiVA
Change search
ReferencesLink to record
Permanent link

Direct link
Cubic SiC formation on the C-face of 6H-SiC (0001) substrates
Linköping University, Department of Physics, Chemistry and Biology, Semiconductor Materials. Linköping University, The Institute of Technology.
CNRS and Université Montpellier 2, Laboratoire Charles Coulomb, Montpellier, France.
Linköping University, Department of Physics, Chemistry and Biology, Semiconductor Materials. Linköping University, The Institute of Technology.
Linköping University, Department of Physics, Chemistry and Biology, Semiconductor Materials. Linköping University, The Institute of Technology.
2012 (English)In: Journal of Crystal Growth, ISSN 0022-0248, E-ISSN 1873-5002, Vol. 348, no 1, 91-96 p.Article in journal (Refereed) Published
Abstract [en]

Nucleation and subsequent growth of cubic SiC (111) on Si- and C-faces of nominally on-axis 6H-SiC substrates was investigated.  More uniform nuclei and twin boundary distribution was observed when 3C-SiC was grown on the C-face. This was attributed to a lower critical supersaturation ratio. A new type of defects which appear as pits in the C-face 3C-SiC layers related to homoepitaxial  6H-SiC  spiral growth was found and described.  The evaluation  of the growth driving force for both polar faces showed that the homoepitaxial 6H-SiC spirals were not overgrown on the C-face  due to low maximum  supersaturation  ratio. The XRD ω-rocking  characterization shows a better structural quality of the 3C-SiC was grown on the Si-face, however on the C-face the uniformity over the whole sample was higher. Unintentional doping by N (~1016  cm-3) was slightly higher on the C-face while Al doping was higher (~1014  cm-3) on the Si-face of the grown material, similarly to the doping of hexagonal SiC polytypes.

Place, publisher, year, edition, pages
2012. Vol. 348, no 1, 91-96 p.
Keyword [en]
A1. Nucleation, A1. Characterization, A1. Polar surfaces A3. Vapor phase epitaxy, B1. Cubic Silicon Carbide.
National Category
Natural Sciences
URN: urn:nbn:se:liu:diva-76363DOI: 10.1016/j.jcrysgro.2012.03.053ISI: 000303937900017OAI: diva2:514112
funding agencies|Swedish Research Council (VR)| 2008-5753 |Angpanneforeningens Forskningsstiftelse||Ericssons Research Foundation||Available from: 2012-04-05 Created: 2012-04-05 Last updated: 2012-06-20Bibliographically approved
In thesis
1. Sublimation Growth and Performance of Cubic Silicon Carbide
Open this publication in new window or tab >>Sublimation Growth and Performance of Cubic Silicon Carbide
2012 (English)Doctoral thesis, comprehensive summary (Other academic)
Abstract [en]

Silicon carbide (SiC) is a wide band gap semiconductor satisfying requirements to replace silicon in devices operating at high power and high frequency at high temperature, and in harsh environments. Hexagonal polytypes of SiC, such as 6H-SiC and 4H-SiC are available on the power device markets. However, the cubic SiC (3C-SiC) polytype is still not industrially used, essentially due to the lack of 3CSiC substrates. This is mainly because of a high density of defects appearing in the  crystals. Thus, it is critical to understand material growth and defect formation, and learn to control their appearance. Ensuring, that growth methods capable of large scale industrial production can be applied.

The aim of this work was to develop operation conditions for fabrication of 3C-SiC crystals via understanding fundamentals of the growth process and to explore structural and electrical properties of the grown material, including its suitability for substrate applications. The physical vapor transport or sublimation process has already shown a capability to produce substantial quantities of large area and high quality hexagonal SiC substrates. In the present study a similar growth principle, but in a different geometry, namely sublimation epitaxy, was applied. Using this method very high growth rates (up to 1 mm/h) can be achieved for hexagonal polytypes while maintaining high material quality. Additionally, the growth process does not require expensive or hazardous materials, thus making the method very attractive for industrial use.

When growing 3C-SiC directly on 6H-SiC, the substrate roughness does not have significant influence on the yield and quality of 3C-SiC. This is mostly due to the growth of homoepitaxial 6H-SiC which appears before the 3C-SiC. Structural characterization showed that 3C-SiC grown directly on 6HSiC exhibited the highest quality as compared with other substrate preparation, such as annealing or deposition of a 3C-SiC buffer layer. Thus, further investigation was devoted to the growth of 3C-SiC on 6H-SiC substrates.

The parameter window for the growth of 3C-SiC is quite narrow. The temperature interval is from ~1675oC, where the material starts to nucleate, to ~1850oC, where an uncontrolled growth process begins. Si-rich conditions (high Si/C ratio) and high supersaturation are needed in the growth chamber for preferable 3C-SiC nucleation. Deviation from these parameters leads to the growth of homoepitaxial 6HSiC in spiral or 2D island mode along with cubic SiC with high defect density.

Nucleation is the most important step in the growth process. The growth on 6H-SiC substrates commences from homoepitaxial 6H-SiC growth in spiral mode, which makes the surface perfect for 3CSiC nucleation. At temperature of ~1675oC the supersaturation is high enough and the 3C-SiC nucleation initiates in two-dimensional islands on the 6H-SiC spiral terraces. Control of the homoepitaxial 6H-SiC growth is a key element in the growth of 3C-SiC.

SiC is a polar material having surfaces terminated by either silicon or carbon atoms, called Si- and C-face, respectively. The growth is different on both faces due to the different free surface energies. The lower surface free energy on the C-face causes more uniform nucleation of 3C-SiC and thereafter more uniform twinned domain distribution. Additionally, calculations showed that increase of growth temperature from 1675oC to 1775oC does not change the supersaturation ratio on the C-face due to a much higher surface diffusion length. This results in appearance of pits in the 3C-SiC layer with a 6H-SiC spiral. The pits were not observed on Si-face material as the supersaturation ratio was much higher. Pits formed in the early stages of growth were overgrown more effectively during the later stages.

Characterization by transmission electron microscopy showed that transformation from 6H-SiC to 3C-SiC is not abrupt and can appear in two different modes. The first one is forming a few micrometers of polytypic transition zone consisting predominantly of 15R-, 6H- and 3C-SiC. The second one appears due to a competition between 3C-SiC and 6H-SiC resulting in a step-like intermixing zone between these polytypes. Four-fold twins were observed, which resulted in depressions at the surface of 3C-SiC. These defects expand proportionally to the layer thickness, thus drastically reducing usable area of thick layers.

Electrical measurements revealed carrier mobility ~200 cm2/Vs at room temperature and the dominant charge carrier scattering is by neutral centers and phonons. The neutral centers originate from extended defects, such as 6H-SiC inclusions, stacking faults and twin boundaries. By growing 3C-SiC on atomically flat and vicinal substrates a preferential orientation of twin boundaries (TBs) was achieved. The mobility was higher in the material with twin boundaries parallel to the current flow, and lower when twin boundaries were perpendicular to the current flow. This was less pronounced at higher temperature as relatively fewer carriers have to overcome barriers created by TBs.

Finally, the substrate capability of the 3C-SiC (111) was demonstrated by growth of a monolayer graphene, which was compared with graphene grown on hexagonal SiC poytypes. The quality of the graphene in terms of thickness uniformity and pit appearance was the best when grown on 3C-SiC. The lower quality on hexagonal substrates was attributed to a more difficult process control which is due to the more complex crystal structure.

Place, publisher, year, edition, pages
Linköping: Linköping University Electronic Press, 2012. 68 p.
Linköping Studies in Science and Technology. Dissertations, ISSN 0345-7524 ; 1435
National Category
Natural Sciences
urn:nbn:se:liu:diva-76371 (URN)978-91-7519-935-1 (ISBN)
Public defence
2012-05-03, Planck, Fysikhuset, Campus Valla, Linköpings universitet, Linköping, 10:15 (English)
Available from: 2012-04-05 Created: 2012-04-05 Last updated: 2012-04-06Bibliographically approved

Open Access in DiVA

fulltext(544 kB)715 downloads
File information
File name FULLTEXT01.pdfFile size 544 kBChecksum SHA-512
Type fulltextMimetype application/pdf

Other links

Publisher's full text

Search in DiVA

By author/editor
Vasiliauskas, RemigijusSyväjärvi, MikaelYakimova, Risitza
By organisation
Semiconductor MaterialsThe Institute of Technology
In the same journal
Journal of Crystal Growth
Natural Sciences

Search outside of DiVA

GoogleGoogle Scholar
Total: 715 downloads
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Altmetric score

Total: 48 hits
ReferencesLink to record
Permanent link

Direct link