liu.seSearch for publications in DiVA
Change search
ReferencesLink to record
Permanent link

Direct link
Dynamic Modeling and Simulation of Digital Displacement Machine
Linköping University, Department of Management and Engineering, Fluid and Mechatronic Systems. Linköping University, The Institute of Technology.
2012 (English)Independent thesis Advanced level (degree of Master (Two Years)), 20 credits / 30 HE creditsStudent thesis
Abstract [en]

Improved efficiency, better controllability and low noise are the most demanding features form a displacement machine now-a-days. Most of the conventional displacement machines are basically a reciprocating pumping element controlled by valve plates or with the help of check valve [1]. This kind of hydraulic machines loose efficiency dramatically at partial displacement because all of the pistons remain at high pressure at the cycle time and due to pressure inside the piston leakage and shear losses increases. One approach to improve the efficiency of the displacement machine can be controlling each hydraulic piston by using programmable faster valves called digital valve. As the total displacement will be controlled digitally, the total system is called Digital Displacement Technology. In digital displacement machine it is possible to disconnect some of the pistons from the load and the piston will connect only with the low pressure side, minimizing losses due to leakage and shear. As the valve will control directly with digital controller it will eliminate the necessity of servo-hydraulic control required by conventional systems. Digital valves can open fully and close again with the input signal within one revaluation of the shaft, so it gives better control to the pumping element results reduction in hysteresis and increase the linearity of the pumping element. In Digital Displacement machines by controlling the valves pistons are connected with the machine when pressure is equal, but in the traditional machines piston connection was pre-determined with the shaft angle. By doing the piston control efficiency of the machine will improve and the sound generates for the decompression flow will be reduced [17]. Also energy storage and recovery can be possible by using accumulator.

Place, publisher, year, edition, pages
2012. , 70 p.
Keyword [en]
Digital Displacement machine, Digital Hydraulics, Hopsan, Digital fluid power, Generic model
National Category
Mechanical Engineering
URN: urn:nbn:se:liu:diva-85277ISRN: LIU-IEI-TEK-A--12/01489-SEOAI: diva2:567944
Subject / course
Fluid and Mechanical Engineering Systems
2012-09-07, S 41 ( C building ), Linköping university, Linköping, 18:06 (English)
Available from: 2012-12-18 Created: 2012-11-14 Last updated: 2012-12-18Bibliographically approved

Open Access in DiVA

Dynamic Modeling and Simulation of Digital Displacement Machine(17891 kB)42475 downloads
File information
File name FULLTEXT01.pdfFile size 17891 kBChecksum SHA-512
Type fulltextMimetype application/pdf

Search in DiVA

By author/editor
Chakraborty, Sanjib
By organisation
Fluid and Mechatronic SystemsThe Institute of Technology
Mechanical Engineering

Search outside of DiVA

GoogleGoogle Scholar
Total: 42475 downloads
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Total: 510 hits
ReferencesLink to record
Permanent link

Direct link