liu.seSearch for publications in DiVA
Change search
ReferencesLink to record
Permanent link

Direct link
Automated control and test system for long time stess tests of microwave ovens
Linköping University, Department of Science and Technology. Linköping University, The Institute of Technology.
2010 (English)Independent thesis Advanced level (degree of Master (One Year)), 20 credits / 30 HE creditsStudent thesis
Abstract [en]

To be able to improve products extensive testing is required in order to find hidden flaws in the design. The earlier flaws are found the higher are the probability that they can be corrected before the product is released onto the market. If the tests could be carried out all hours of the day every day of the week, this would introduce another level of stress to the product. More stress than if the product would be tested only during working days and it may reveal issues that could be corrected to improve the product further. Although a similar test environment already exists at Whirlpool Sweden AB, there are requests to rethink and improve these tests so that the microwave ovens are tested in an environment more close to reality. This thesis will present a concept proposal of how to improve the tests. Further, the thesis will include initial construction of a machine that could perform automated tests with the ability to interpret errors and report them. In the end, the machine should press buttons on the microwave oven, look at the display with a camera, open the door and so on.

The mechanics for the machine is bought, so a big part of the thesis will be electronics design. The project will include an embedded system design with a 32-bit ARM micro controller that is going to control the machine. As this part is quite big the thesis will include the hardware design, but not much programming.

The hardware design of the embedded system did work as expected, without any revisions. The hardware has been verified by electrical tests and basic software to test the general functions of the hardware. In the future, the hardware needs programming and the machine has to be equipped with a mechanical finger to be able to press buttons.

Keywords: Embedded system design, ARM, Cortex-M3, , Linear guide, Stepper


Place, publisher, year, edition, pages
2010. , 65 p.
National Category
Engineering and Technology
URN: urn:nbn:se:liu:diva-93515ISRN: LiU-ITN-TEK-A--10/061--SEOAI: diva2:629443
Subject / course
Electrical Engineering
Available from: 2013-06-17 Created: 2013-06-04 Last updated: 2013-06-18Bibliographically approved

Open Access in DiVA

fulltext(4067 kB)196 downloads
File information
File name FULLTEXT01.pdfFile size 4067 kBChecksum SHA-512
Type fulltextMimetype application/pdf

Search in DiVA

By author/editor
Appelgren, Anders
By organisation
Department of Science and TechnologyThe Institute of Technology
Engineering and Technology

Search outside of DiVA

GoogleGoogle Scholar
Total: 196 downloads
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Total: 60 hits
ReferencesLink to record
Permanent link

Direct link