liu.seSearch for publications in DiVA
Change search
ReferencesLink to record
Permanent link

Direct link
Robust repair methods of primary structures in composite
Linköping University, Department of Management and Engineering, Solid Mechanics.
Linköping University, Department of Management and Engineering, Solid Mechanics.
2013 (English)Independent thesis Basic level (degree of Bachelor), 10,5 credits / 16 HE creditsStudent thesis
Abstract [en]

A request of material change when performing repairs on composite parts of SAABs JAS 39 Gripen has lead to the initiation of this project. The aim is to create a quicker and more robust repair method. The requested method of repair is to use a direct-cured repair patch made of CFRP fabric instead of CFRP tape and to mount the patch with a scarf joint, see Figure 1.1. The fabric patch should then provide a robust quasi-isotropic repair, where the operator not is dependent of complete design data such as ply-directions etc. Today tape repairs are made on tape laminate and fabric repairs made on fabric laminate. The new method is to repair tape laminate with a fabric patch. This project will evaluate the possibility of implementing this method.

The work started with a literature study to find out how repairs in composite parts of the airframe are being performed today. SAABs in-house analytical tools were then used to try to predict the results and examine some of the details in the questions at issue.

Finite element models were then constructed to simulate a previous physical test program conducted to validate a repair method using a step joint and a direct-cured repair patch. If the FE models could show similar results as the physical tests the results from the FE models then can be assumed to be credible.

The results of this project indicate that the change from fabric to tape in the repair patch can be done without disturbing the load path of a quasi isotropic composite laminate. Fabric repairs in orthotropic composite plates results in a knock-down of about 40%. The use of a scarf joint instead of a step joint should also work well as the repair patches show similar strains in the centre of the patches. The difference between step joint and scarf joint is the strain near the edge of the patch. It increases with scarf joint and it may lead to an earlier fibre failure in the repair patch.

Results from the analysis of the bonded joint indicate that a scarf joint yields in a lower and more evenly distributed shear stress than the step joint. This indicates that the bonded joint in the step joint will reach failure earlier then the scarf joint.

Place, publisher, year, edition, pages
2013. , 63 p.
Keyword [en]
Composite, Repair, Scarf joint, Step joint, Fabric, Tape, FEM
National Category
Mechanical Engineering
URN: urn:nbn:se:liu:diva-94362ISRN: LIU-IEI-TEK-G--13/00402--SEOAI: diva2:632489
External cooperation
Subject / course
Solid Mechanics
2013-06-05, A27, Linköping, 10:07 (Swedish)
Available from: 2013-08-19 Created: 2013-06-25 Last updated: 2013-08-19Bibliographically approved

Open Access in DiVA

Robust repair methods of primary structures in composite(762 kB)960 downloads
File information
File name FULLTEXT01.pdfFile size 762 kBChecksum SHA-512
Type fulltextMimetype application/pdf

Search in DiVA

By author/editor
Ramström, MarcusGungner, Mattias
By organisation
Solid Mechanics
Mechanical Engineering

Search outside of DiVA

GoogleGoogle Scholar
Total: 960 downloads
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Total: 220 hits
ReferencesLink to record
Permanent link

Direct link