Development of Test Equipment for Analysis of Camera Vision Systems Used in Car Industry: Printed Ciruit Board Design and Power Distribution Network Stability
Independent thesis Basic level (degree of Bachelor), 10 credits / 15 HE creditsStudent thesis
The main purpose of this thesis was to develop a printed circuit board for Autoliv Electronics AB. This circuit board should be placed in their test equipment to support some of their camera vision systems used in cars. The main task was to combine the existing hardware into one module.
To be able to achieve this, the most important factors in designing a printed circuit board was considered. A satisfying power distribution network is the most crucial one. This was accomplished by using decoupling capacitors to achieve low enough impedance for all circuits. Calculations and simulations were executed for all integrated circuits to find the correct size and numbers of capacitors.
The impedance of the circuit board was tested with a network analyzer to confirm that the impedance were low enough, which was the case. System functionality was never tested completely, due to delivery problems with some external equipment.
Place, publisher, year, edition, pages
2015. , 84 p.
Printed Circuit Board, Power Distribution Network, Decoupling Capacitors, Camera Vision System, Controller Area Network
Electrical Engineering, Electronic Engineering, Information Engineering
IdentifiersURN: urn:nbn:se:liu:diva-121806ISRN: LiTH-ISY-EX-ET--15/0445--SEOAI: oai:DiVA.org:liu-121806DiVA: diva2:859473
Autoliv Electronics AB
Subject / course
Integrated Circuits and Systems
2015-08-28, Nollstället, B-building, Linköping University, Linköping, 14:00 (English)
Johansson, PeterDannebro, MagnusForsberg, Mattias
Wikner, J Jacob, Dr.