Monitoring the vast number of micropollutants in the environment by using comprehensive chemical screening is a major analytical challenge. The aim of this study was to evaluate a comprehensive analysis method for screening purposes of fish muscle samples by comparing sample preparation methods for a broad range of mid-to non-polar contaminants. Five extraction and three clean-up methods were evaluated for the analysis of 60 compounds with a log Kow range between 0.8 and 8.3 in fish. Both fresh and freeze-dried muscle tissue and extraction sodium sulphate blanks were included to assess recoveries and matrix effects. The performance of the different methods was evaluated using both comprehensive target and nontarget analysis using high resolution mass spectrometry (HRMS). The results showed that open-column and ultrasonication extractions (recoveries mostly between 20 and 160 %) resulted in higher recoveries than accelerated solvent extraction (ASE) (recoveries mostly between 20 and 80 %) and bead mixer homogenization extractions (recoveries between 0 and 50 % for the whole Kow range). Multilayer silica was the clean-up method resulting in the lowest matrix effects and highest recoveries, however some compounds (mostly pesticides) were denatured under the acidic conditions used. The convenient and time efficient ultrasonication extraction followed by deactivated silica clean-up proved to be promising for both target and nontarget approaches. The large difference in recoveries and number of detected peaks using target and nontarget approaches between fresh and freeze-dried fish seen for all methods calls for careful consideration, and further studies are needed to improve performance for screening of mid-to non-polar compounds in freeze-dried fish.

The vast number of per- and polyfluoroalkyl substances (PFASs) that are in global commerce (n > 4700) pose immense challenges for environmental monitoring. The large discrepancy between this large number and the few PFASs usually monitored suggest that environmental exposure might be substantially underestimated. This study applied a workflow, which included analysis of total fluorine (TF), extractable organofluorine (EOF), 24 target PFASs and suspect screening. The workflow aimed to close the organofluorine mass balance and to tentatively identify overlooked PFASs in various matrices from an aqueous film forming foam (AFFF) contaminated pond and its adjacent riparian zone. PFAS target analysis revealed that water, aquatic invertebrates as well as emergent aquatic insects had high concentrations with up to 2870 ng L-1, 9230 ng g-1 dry weight (dw) and 1470 ng g-1 dw ∑24PFASs, respectively. The EOF mass balance could be explained by target PFAS analysis for most biota samples such as aquatic invertebrates, emergent aquatic insects and terrestrial spiders and earthworms (i.e. EOF ≈ ∑24PFASs). In the pond surface water, 42-58% of the EOF was not explained by target PFASs. However most new tentatively identified PFASs (n = 25) were detected in water, which could contribute to the unknown EOF. Nine suspects could be further identified, which where perfluoroalkyl sulfonamide-based compounds and derivatives that all have been found in historical AFFFs produced by electrochemical fluorination. One suspect, F5S-PFOS, was also detected for the first time in aquatic and terrestrial invertebrates. 

Since humans spend more than 90% of their time in indoor environments, indoor exposure can be an important non-dietary pathway to hazardous organic contaminants. It is thus important to characterize the chemical composition of indoor dust to assess the total contaminant exposure and estimate human health risks. The aim of this investigation was to perform a comprehensive chemical characterization of indoor dust. First, the robustness of an adopted extraction method using ultrasonication was evaluated for 85 target compounds. Thereafter, a workflow combining target analysis, suspect screening analysis (SSA) and nontarget analysis (NTA) was applied to dust samples from different indoor environments. Chemical analysis was performed using both gas chromatography and liquid chromatography coupled with high resolution mass spectrometry. Although suppressing matrix effects were prominent, target analysis enabled the quantification of organophosphate/brominated flame retardants (OPFRs/BFRs), liquid crystal monomers (LCMs), toluene diisocyanate, bisphenols, pesticides and tributyl citrate. The SSA confirmed the presence of OPFRs but also enabled the detection of polyethylene glycols (PEGs) and phthalates/parabens. The combination of hierarchical cluster analysis and scaled mass defect plots in the NTA workflow confirmed the presence of the above mentioned compounds, as well as detect other contaminants such as tetrabromobisphenol A, triclocarban, diclofenac and 3,5,6-trichloro-2-pyridinol, which were further confirmed using pure standards.

Recent publications have highlighted the ubiquitous presence of unidentified organofluorine compounds, whose environmental occurrence is poorly understood. In this study, wastewater treatment plant (WWTP) effluent and sludge samples from seven countries were analyzed for extractable organofluorine (EOF) and target PFAS, to evaluate which compounds are released back into the environment. Fluorine mass balance analysis of effluent samples (n = 14) revealed that on average 90% of the EOF could not be explained by the 73 PFAS monitored in this investigation. The levels of EOF in effluent (324–1460 ng of F/L) and sludge (39–210 ng of F/g of dry weight) indicate that a substantial amount of organofluorine compounds is released back into nature. A commonly overlooked PFAS class, ultra-short-chain PFCAs, accounted for 4% of EOF on average, while the remaining 71 compounds explained only a further 6% of EOF on average. The highest number of PFAS was detected in the effluent dissolved phase (37), compared to 29 and 23 PFAS in sludge and effluent particulate phase, respectively. The increased concentrations of EOF in both WWTP effluent and sludge are of concern, as the chemical species contained therein remain largely unknown, and thus, their potential health and environmental risks cannot be assessed.

Emergent aquatic insects are important food subsidies to riparian food webs but can also transfer waterborne contaminants to the terrestrial environment. This study aimed to quantitatively assess this biodriven transfer for per- and polyfluoroalkyl substances (PFAS). Aquatic insect larvae, emergent aquatic insects, terrestrial consumers, sediment, and water were collected from a contaminated lake and stream and an uncontaminated pond, and analyzed for PFAS and stable isotopes of carbon and nitrogen. Top predators in this study were spiders, which showed the highest average ∑24PFAS concentration of 1400 ± 80 ng g-1 dry weight (dw) at the lake and 630 ng g-1 dw at the stream. The transfer of PFAS from the lake to the riparian zone, via deposition of emergent aquatic insects, was 280 ng ∑24PFAS m-2 d-1 in 2017 and only 23 ng ∑24PFAS m-2 d-1 in 2018. Because of higher production of emergent aquatic insects, the lake had higher PFAS transfer and higher concentrations in terrestrial consumers compared to the stream, despite the stream having higher PFAS concentration in water and aquatic insect larvae. Our results indicate that biodriven transfer of PFAS from the aquatic systems and subsequent uptake in terrestrial food webs depend more on emergence amounts, i.e., aquatic prey availability, rather than on PFAS concentrations in water and aquatic prey. 

Aqueous film-forming foams (AFFFs) are widely used to extinguish liquid fires due to their film-forming properties. AFFF formulation historically contains per- and polyfluoroalkyl substances (PFASs) that can be very persistent and pose a health risk to biota and humans. Detailed analysis of the chemical composition of AFFFs can provide a better understanding on the potential environmental impact of the ingredients. In this study, a novel workflow combining target analysis, nontarget screening analysis (NTA), total fluorine (TF) analysis, and inorganic fluoride (IF) analysis was applied to disclose the chemical composition of 24 foams intended for liquid fires. Foams marketed as containing PFASs as well as fluorine-free foams were included. By comparing the sum of targeted PFASs and total organofluorine concentrations, a mass balance of known and unknown organofluorine could be calculated. Known organofluorine accounted for <1% in most fluorine-containing AFFFs, and it was confirmed that the foams marketed as fluorine-free did not contain measurable amounts of organofluorine substances. Five fluorinated substances were tentatively identified, and non-fluorinated zwitterionic betaine compounds, which are considered to be replacement substances for PFASs, were tentatively identified in the organofluorine-free foams.

During a fire event, potentially hazardous chemicals are formed from the combustion of burning materials and are released to the surrounding environment, both via gas and soot particles. The aim of this investigation was to study if firefighting techniques influence the emission of chemicals in gas phase and soot particles. Five full-scale fire tests were extinguished using four different firefighting techniques. A nontarget chemical analysis approach showed that important contaminants in gas and soot separating the different tests were brominated flame retardants (BFRs), organophosphate flame retardants (OPFR), polycyclic aromatic hydrocarbons (PAHs) and linear hydrocarbons. Reproducibility was evaluated by a field replicate test and it was determined that the temperature curve during the event had a bigger impact on the released chemicals than the firefighting technique used. However, despite fire intensity being a confounding factor, multivariate statistics concluded that water mist with additive resulted in less BFR emissions compared to foam extinguishing. The analysis also showed that the conventional spray nozzle method released more PAHs compared with the water mist method. The comprehensive chemical analysis of gas and soot released during fire events was able to show that different firefighting techniques influenced the release of chemicals. 

The occurrence of per- and polyfluoroalkyl substances (PFASs) in aquatic ecosystems is a global concern because of their persistence, potential bioaccumulation, and toxicity. In this study, we investigated a PFAS-contaminated pond in Sweden to assess the cross-boundary transfer of PFASs from the aquatic environment to the riparian zone via emergent aquatic insects. Aquatic and terrestrial invertebrates, surface water, sediments, soils, and plants were analyzed for 24 PFASs including branched isomers. Stable isotope analysis of carbon and nitrogen was performed to elucidate the importance of diet and trophic position for PFAS uptake. We present the first evidence that PFASs can propagate to the riparian food web via aquatic emergent insects. Elevated Σ₂₄PFAS concentrations were found in aquatic insect larvae, such as dragon- and damselflies, ranging from 1100 to 4600 ng g^-1 dry weight (dw), and remained high in emerged adults (120-3500 ng g^-1 dw), indicating exposure risks for top predators that prey in riparian zones. In terrestrial invertebrate consumers, PFAS concentrations increased with the degree of aquatic-based diet and at higher trophic levels. Furthermore, stable isotope data together with calculated bioaccumulation factors indicated that bioconcentration of PFASs was the major pathway of exposure in the aquatic food web and bioaccumulation in the riparian food web.

This report describes a screening study of in all ninety-nine conventional and emerging per- and polyfluoroalkyl substances (PFASs) in the Nordic environment. In addition, extractable organic fluorine (EOF) was analysed. The latter can provide the amount, but not identity, of organofluorine in the samples, which in turn can be used to assess the mass balance between known and unknown PFASs. The study was initiated by the Nordic Screening Group and funded by these and the Nordic Council of Ministers through the Chemicals Group. A total of 102 samples were analyzed in this study, including bird eggs, fish, marine mammals, terrestrial mammals, surface water, WWTP effluents and sludge, and air. Samples were collected by institutes from the participating countries and self-governing areas; Denmark, Faroe Islands, Finland, Greenland, Iceland, Norway, and Sweden.

Major point sources of per- and polyfluoroalkyl substances (PFASs) cause ubiquitous spread of PFASs in the environment. In this study, surface water and aquatic invertebrates at three Swedish sites impacted by PFAS point sources were characterized, using homologue, isomer and extractable organofluorine (EOF) profiling as well as estimation of bioaccumulation factors (BAFs) and mass discharge. Two sites were impacted by fire training (sites A and R) and the third by industrial runoff (site K). Mean Σ25PFASs concentration in water was 1920 ng L-1 at site R (n = 3), which was more than 20- and 10-fold higher than those from sites A and K, respectively. PFOS was the most predominant PFAS in all waters samples, constituting 29-79% of Σ25PFAS concentrations. Several branched isomers were detected and they substantially contributed to concentrations in surface water (e.g. 49-78% of ΣPFOS) and aquatic invertebrates (e.g. 15-28% of ΣPFOS). BAFs in the aquatic invertebrates indicated higher bioaccumulation for long chain PFASs and lower bioaccumulation for branched PFOS isomers compared to linear PFOS. EOF mass balance showed that Σ25target PFASs in water could explain up to 55% of EOF at site R. However, larger proportions of EOF (>92%) remained unknown in water from sites A and K. Mass discharges were for the first time estimated for EOF and revealed that high amounts of EOF (e.g. 8.2 g F day-1 at site A) could be transported by water to recipient water bodies relative to Σ25PFASs (e.g. 0.15 g day-1 at site A). Overall, we showed that composition profiling, BAFs and EOF mass balance can improve the characterization of PFASs around point sources.