Lithium-ion batteries (LIBs) have revolutionised society due to their lightweight, energy-dense, and rechargeable properties. Due to increased energy consumption and the desire to expand green energy for a more sustainable future, there is a high demand for LIBs in the market. The use of LIBs entails certain safety risks, where the battery can sometimes enter a state called thermal runaway (TR). This state causes violent and difficult-to-extinguish fires. If it occurs in a battery pack, TR in one cell spreads rapidly to the surrounding cells, imposing even larger safety risks for the people in its vicinity. To minimize the risk of TR and stop its spread in a battery pack, active or passive cooling systems can be utilised. Passive systems are often used when weight, volume, and the price of the object need to be considered. In this study, a high thermal conductivity (TC) composite has been manufactured for passive cooling systems with the aim of mitigating TR in LIB packs. The manufacturing process has been varied to investigate its effect on the composite. The composite itself consisted of a thermoset matrix (IN2 infusion Epoxy) and a reinforcement of hexagonal boron nitride (h-BN) particles. A high TC composite was manufactured with a solids loading of 75 wt% h-BN, mixed in a resonant acoustic mixer, pressed in a hydraulic press, and thereafter cured in indoor air overnight. The density was measured to be 1.81 g/cm3, and the TC ranged between 6.1-6.9 W/mK. The material was electrically insulating and had high mechanical strength. A prototype was designed for seven LIBs, and successfully manufactured. An over charging test was performed. It was concluded that the cooling effect was too low, and the prototype would most likely not be able to mitigate TR in a real scenario with several LIB packs. However, the test confirmed that the composite can withstand temperatures of 300 °C. A syringe-based 3D printer was used to print the composite material, with promising results regarding the voidless interior that was achieved. More work in this area is desired due to the potential material savings and manufacturing improvements that could be achieved.