Reducing the radar cross section has been of interest for a long time. SrFe12O19has shown promise as a radar absorbing material due to its high magnetocrystallineanisotropy. Its magnetic properties depend on its particle size and thereforeit is of interest to study how milling affect its particle size distribution andmagnetic properties. Since the radar absorbing properties are dependent on themagnetic properties of a material the aim is to study the impact particle size distributionhave on radar absorbing properties.The SrFe12O19 powder was milled for 0, 80, 240 and 320 minutes, called P0, P80,P240 and P320, to achieve different size distributions as a result of the millingprocess. The milling process apart from reducing size can also induce strain in the crystallite and change the material’s magnetic anisotropy. The structure of thesamples were analyzed with XRD. The particle size distribution was done withlaser diffraction which showed much larger particle sizes than expected fromthe original powder. It was assumed agglomeration had occurred. SEM was employedto validate size distributions and study the morphology of the samples. Tomeasure the magnetic properties vibrating sample magnetometer was preformed.The radar absorbing properties was studied with a waveguide. To perform thewaveguide experiments prisms of 80 wt% SrFe12O19 with paraffin was made.The milling did alter the SrFe12O19 radar absorbing properties. There was a secondphase of Fe3O4 present from the start, which altered the magnetic propertiesof the samples. The result from milling was primarily a reduction of size of thelargest particles to a more narrow size distribution. The results showed a need fora thick Dallenbach layer, minimum 8 mm. The maximum achieved bandwidthwas 0.895 GHz (around 11.8 GHz) for a 12 mm thick layer.