Time-resolved ion mass spectrometry was used to investigate the ion fluxes present during high-power impulse magnetron sputtering of a Bi target in an argon atmosphere. The study focuses on the temporal evolution of singly, doubly, and triply charged Bi ions (Bi+, Bi2+, and Bi3+) under two different discharge conditions with varying peak target current densities (J(T)) and pulse frequencies (f). The results show that Bi2+ and Bi3+ ions dominate the ion population in the postpulse plasma, with Bi2+ exhibiting the highest flux across both discharge conditions. Interestingly, the lower peak target current density J(T) = 0.07 A/cm(2) (f = 2000 Hz) results in higher total ion fluxes and longer ion persistence compared to those detected with J(T) of 0.18 A/cm(2) (f = 700 Hz). Severe Ar gas rarefaction, enhanced by the high sputter yield and large mass of Bi, strongly influences the ion energy distribution functions. Both Bi2+ and Bi3+ exhibit a dominant low-energy peak (0-10 eV) from ions emitted in preceding pulses, together with broad Sigmund-Thompson-like tails extending up to similar to 25-30 eV due to ions generated during the ongoing discharge. At J(T) = 0.07 A/cm(2) (f = 2000Hz), the short off-time (470 mu s) is insufficient for full ion thermalization, resulting in residual high-energy ions persisting into the early afterglow. In contrast, at 0.18 A/cm(2) (f = 700 Hz), the longer off-time (similar to 1.4 ms) enables complete thermalization. As a result, the mean ion charge state remains above 2.0 in both cases but is slightly higher at lower J(T) (2.17-2.28 vs 2.07-2.15). These findings provide practical guidelines for substrate biasing: bias should be applied after similar to 90 mu s to minimize Ar implantation and optimized at reduced amplitudes (2-3 times lower than for Ta or W) to take advantage of the high Bi charge states without inducing excessive ion damage.
Funding Agencies|Swedish Energy Agency [P2023-00784]; Aforsk Foundation [22-4]; Carl Tryggers [CTS 24:3188]; Swedish Government Strategic Research Area in Materials Science on Advanced Functional Materials at Linkoping University [2009-00971]; Competence Center Functional Nanoscale Materials (FunMat-II) VINNOVA [2022-03071]; Warsaw University of Technology as part of the Excellence Initiative: Research University (IDUB) Mobility program [CPR-IDUB/21/Z09/2024]