Numerous methods have been suggested to quantify fatigue-initiating defect size on fracture surfaces, the most prevalent are based on the Murakami-Endo /area-parameter. However, there is an ambiguity in how systemically determine defect areas. For instance, in literature on high-cycle fatigue of ductile cast irons the several different methods have been suggested: (i) the traced contour, (ii) the convex hull, (iii) the minimum circumscribed circle, and (iv) the minimum bounding rectangle. This work focuses on comparing and evaluating these methods by assessing the fatigue-initiating defect area distributions, and the influence on fatigue assessment using the /area-parameter. To this end, very high cycle fatigue data on ductile cast irons with different microstructures is used, where complex shaped defects are the root-cause for fatigue failures. It is shown that there is a significant difference in the area distributions, originating from the applied area measurement method. In addition, to enable and include fatigue assessment of high strength ausferritic ductile irons, two improved Murakami-Endo type models are proposed, which show satisfactory prediction capabilities over a wide range of ductile cast iron microstructures. To further evaluate the different area measurement methods, the suggested models are validated against ductile cast iron high-cycle fatigue data from literature having artificial defects and notches. Finally, it is concluded that the traced contour defect measurement method yields the best agreement between artificial and natural defects, and overall, the least prediction errors.
Funding Agencies|Epiroc Rock Drills AB; Vinnova, The Swedish Energy Agency; Formas under the strategic innovation program Metallic Materials [2021-04007]