Analysis and development of X-band downconverters
2026 (English)Independent thesis Advanced level (degree of Master (Two Years)), 28 HE credits
Student thesis
Abstract [en]
This project aims to investigate whether it’s feasible to develop a single prototype X-banddownconverter with readily available, low-cost components. The study begins by identifyingsuitable architectures using cascade equations, to estimate system performance and filter outarchitectures and components which do not fulfil the target specification. The architecturesfulfilling the target specification are then analysed in detail using nonlinear simulations inKeysight ADS.
Two downconverter designs were developed, the first with connectorized components andthe second with surface-mounted components. The connectorized receiver was physicallyconstructed to verify consistent behaviour between simulated and real-world performance. APCB for the surface-mounted components was also designed and simulated. EM simulationswere carried out on the RF part of the PCB to identify differences between the schematicand layout views and ensure there is no crosstalk between components at signal-integritycompromisinglevels.
Component models were created using datasheet information containing frequency-dependentIIP3 and P1dB, and supplier-provided S-parameters for components lacking sufficiently sophisticatedmodels. Components lacking S-parameters were measured to find their S-parameters.The simulated connectorized downconverter was compared with a measured downconverterbased on the simulated design to ensure that the models used can predict system behaviour.
Finally, the evolution of system performance through the design flow was analysed to determinethe simulation level required for reliable downconverter design.
Simulation results and calculated performance indicate that the development of X-band downconvertersusing connectorized components can be performed without simulation software.However, simulation software and a PCB design tool are necessary if the design is to bemounted on a PCB.
The resulting connectorized and surface-mounted downconverter proves that it is possible todevelop high-frequency, low-cost downconverters at small scales within a short time frame.
Place, publisher, year, edition, pages
2026. , p. 45
Keywords [en]
X-Band, Downconverter, Transceiver, Receiver
National Category
Electrical Engineering, Electronic Engineering, Information Engineering
Identifiers
URN: urn:nbn:se:liu:diva-226094ISRN: LiTH-ISY-EX–26/5893–SEOAI: oai:DiVA.org:liu-226094DiVA, id: diva2:2084369
External cooperation
FOI
Presentation
2026-06-11, Nollstället, Hus B 27 Valla, Linköping, 21:50 (English)
Supervisors
Examiners
2026-07-062026-07-042026-07-06Bibliographically approved